Adjusting The Density When Scanning - Oki MB492dn User Manual

Adjusting the Density When Scanning

This section describes how to change the default setting of the density when scanning. You can adjust the density in seven levels.
1.
Press [Device Settings] on the touch panel.
2.
Press [Admin Setup].
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Press [OK].
5.
Press [Scanner Setup].
6.
Press [Default Settings].
7.
Press [Image Settings].
8.
Press [Density].
9.
Select a value.
10.
Press [Back] until the home screen is displayed.
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
808