Setting By Using Eap-Tls - Oki MB492dn User Manual

Setting by Using EAP-TLS

This machine supports the IEEE802.1X authentication.
Set up this machine and the computer before following the procedure below.
About initial setup and IP address
Preparations Required
1.
Open the Web page of this machine.
About the IP address of this machine
Setting an IP Address from the Operator Panel on This Machine
How to log in to the Web page
About the Web Page of This Machine
2.
Log in as the administrator.
How to log in as the administrator
About the Web Page of This Machine
3.
Select [Admin Setup].
4.
Select [Network] > [IEEE802.1X].
5.
Select [Enable] for [IEEE802.1X].
6.
Select [EAP-TLS] for [EAP Type].
7.
Enter a user name in [EAP User].
8.
Select [Do not use SSL/TLS Certificate for EAP authentication], and then click [Import].
9.
Enter the file name of the certificate.
You can only import a PKCS#12 file.
10.
Enter the password of the certificate, and then click [OK].
11.
Select [Authenticate Server], and then click [Import].
12.
Enter the file name of the CA certificate, and then click [OK].
Specify the certificate issued by the certificate authority that the RADIUS server obtained. You can import a PEM, DER, and PKCS#7
file.
13.
Click [Submit].
The new settings take effect when the network function of this machine restarts.
14.
Turn the machine off after this machine becomes online.
15.
Connect the LAN cable to the network interface connector.
16.
Connect the LAN cable to the authentication port of an authentication switch.
17.
Turn the machine on.
18.
Set up this machine.
1172