Connecting With A Lan Cable (Network Connection) - Oki MB492dn User Manual

Connecting with a LAN Cable (Network Connection)

If there is no DHCP server on a network, you must set the IP address on a computer or machine manually.
Even if you are instructed to set a unique IP address that is specified by your network administrator, Internet service provider, or router
manufacturer, you must set the IP address to the computer and machine manually.
Note
Complete the network setting of the computer before this procedure.
You must log in as the administrator.
If you set an IP address manually, contact your network administrator or Internet service provider for the IP address to use. If the
IP address is set incorrectly, the network may go down or Internet access may be disabled.
Memo
If you construct a small network that consists of only the machine and a computer, set IP addresses as shown below (according to
RFC1918).
For the computer
IP address: 192.168.0.1 to 254
Subnet mask: 255.255.255.0
Default gateway: Not used
DNS server: Not used
For the machine
IP address setting: Manual
IP address: 192.168.0.1 to 254 (Select a different value from the computer's IP address.)
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
Network scale: Small
To set [Network Scale], select [Device Settings] > [Admin Setup] > [Network Menu] > [Network Setup] > [Network Setting] >
[Network Scale] > [Small].
1.
Prepare a LAN cable and hub.
Prepare a LAN cable (category 5 or higher, twist pair, straight) and hub.
2.
Turn the machine and computer off.
Turning the Machine Off
3.
Attach the core to the LAN cable.
Wind the LAN cable in a double loop at 2 to 3 cm from the end of the cable, and then attach the core to the looped cable.
4.
Insert one end of the LAN cable into the network interface connector.
901