Limiting By Using An Ip Address (Ip Filtering) - Oki MB492dn User Manual

Limiting by Using an IP Address (IP Filtering)

You can control access to the machine by using an IP address. You can set whether to allow for setting or printing from a specified IP
address. IP filtering is disabled by factory default.
Note
Be sure to specify the correct IP address. An incorrect entry of an IP address does not allow for access to the printer by using the
IP protocol.
If you enable IP filtering, access to hosts that are not specified in this setting is rejected.
1.
Open the Web page of this machine.
About the IP address of this machine
Setting an IP Address from the Operator Panel on This Machine
How to log in to the Web page
About the Web Page of This Machine
2.
Log in as the administrator.
How to log in as the administrator
About the Web Page of This Machine
3.
Select [Admin Setup].
4.
Select [Network] > [Security] > [IP Filtering].
5.
Specify detailed settings by following the on-screen instructions.
Note
If nothing is registered in [Administrator's IP Address to Register], any access to the machine may not be allowed depending
on the specified IP address range.
If you use a proxy server, [Your Current Local Host/Proxy IP Address] and the IP address of your host may not match.
6.
Click [Submit].
The new settings take effect when the network function of this machine restarts.
Memo
You can use only IPv4 for IP filtering.
1151