Setting From The Operator Panel Manually To Connect - Oki MB492dn User Manual

Setting from the Operator Panel Manually to Connect

Set the wireless LAN access point information (the SSID, encryption method, and encryption key) manually to connect to the wireless
LAN.
Set by following the procedure below.
1.
Check the SSID and encryption key by referring to the instruction manual that is included in a wireless
LAN access point or other documents, and write the information down.
Note
If the encryption method is WPA2-EAP, set from the Web page of this machine.
For details, open the Web page of this machine and click [Admin Setup] > [Network] > [Wireless Setting] > [Manual Setup].
Using the Web Page of This Machine
Memo
An SSID is also called a network name, ESSID, or ESS-ID.
An encryption key is also called a network key, security key, password, or Pre-shared Key.
2.
Check that the wireless LAN access point starts and is operating properly.
3.
Turn the machine on.
Memo
If the following screen is displayed, press [Yes], and then proceed to step 6.
4.
Press [Device Settings].
5.
Press [Wireless Setting].
6.
Enter the administrator password, and then press [OK].
The factory default password is "aaaaaa".
The following message is displayed for approximately 5 seconds.
897