Oki MB492dn User Manual page 672

Jam Recovery
Paper Black
Setting
Darkness
SMR Setting
BG Setting
Print Tray 1
Position
Adjust
Tray 2
(Optional)
MP Tray
Drum Cleaning
Hex Dump
System Personality
Configuration
Menu
Alarm Release
Auto Continue
Error Report
PCL Setup Font Source
Font No.
Font Pitch
Font Height
Enable Sets whether to print the pages again that are not printed due to a
paper jam after the jam is cleared.
0 Corrects the unevenness of printed characters caused by temperature
differences.
Change the value if the characters are faded.
0 Sets print darkness.
0 Corrects variations in print results caused by temperature and humidity
conditions and differences in print density and frequency. Change the
setting if the print quality is uneven.
0 Corrects variations in print results caused by temperature and humidity
conditions and differences in print density and frequency. Change the
setting if the background is dark.
X 0 mm
Adjust
Y 0 mm
Adjust
Duplex 0 mm
X
Adjust
Duplex 0 mm
Y
Adjust
X 0 mm
Adjust
Y 0 mm
Adjust
Duplex 0 mm
X
Adjust
Duplex 0 mm
Y
Adjust
X 0 mm
Adjust
Y 0 mm
Adjust
Duplex 0 mm
X
Adjust
Duplex 0 mm
Y
Adjust
OFF Sets whether to clean the drum before printing. The image quality
improvement may be expected.
OFF Prints out the data received from the host computer in hex. To finish
printing, turn the machine off.
Auto Selects the emulation mode. If auto is set, the correct emulation is
automatically selected every time a print job is received.
Manual If [Manual] is set, non-critical warnings, such as requests for a different
paper size, can be cleared by pressing [RESET]. If [Auto] is set, the
warnings are cleared when the print job resumes.
OFF Sets whether the machine automatically recovers from a memory
overflow.
OFF Sets whether to print error details if PostScript errors occur.
Resident Selects the location of the font to use.
I0 Selects the font number to use.
Available range: I0 to I90 if [Resident] is set/C1 to C4 if [Resident 2] is
set
10.00 CPI Sets the width of the PCL default font.
Available range: 0.44 to 99.99 CPI (0.01CPI increments).
12.00 point(s) Sets the height of the PCL default font.
X Adjust: Adjusts the position of the entire printing image
perpendicular to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Y Adjust: Adjusts the position of the entire printing image parallel to
the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Duplex X Adjust: Adjusts the position of the image on the back side of
a duplex print perpendicular to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
Duplex Y Adjust: Adjusts the position of the image on the back side of
a duplex print parallel to the direction of paper movement.
Available range: ±2.00 mm (0.25 increments).
671