1.19 MOBILE PHONE/DISPLAY MODE
By default this mode is disabled. There is a big improvement in reading barcodes
displayed on mobile phones and electronic displays when this mode is enabled.
1.20 SERIAL NUMBER STAMP
Decide whether to add the device serial number in front of the data transmitted.
1.20.1 SEPARATOR BETWEEN SERIAL NUMBER STAMP AND DATA
Scan the barcode below to specify the separator character between device serial number
and the accompanying data. By default, the separactor is a comma symbol.
1) Read the barcode above to specify a separator character.
2) Read the
"Hexadecimal
3) Read the "Validate" barcode to complete this setting.
Chapter 1
Add serial number in
separator character
Value" barcode on page 262 for the desired character.
Understanding the Barcode Scanner
Enable
*Disable
front of data
*Disable
Specify the
Update
53