3610 Serial Commands And Equivalent Setup Barcodes - CipherLab 1662 User Manual

1662/1664 Barcode Scanner

3610 SERIAL COMMANDS AND EQUIVALENT SETUP BARCODES

Config<CR>
Purpose To configure 3610.
Here is the setup barcode for this serial command:
Remarks A list of the current settings will be displayed. Run HyperTerminal.exe on your
computer and change the settings one by one.
DefaultSetting<CR>
Purpose To restore the default settings.
Here is the setup barcode for this serial command:
SingleConnection<CR>
Purpose To allow only one scanner connecting to 3610.
Here is the setup barcode for this serial command:
MultiConnection<CR>
Purpose To allow up to seven scanners connecting to 3610.
Here is the setup barcode for this serial command:
UseOnePortforAll<CR>
Purpose To use one Virtual COM port for all whenever connecting 3610 to PC via USB. This
setting requires to connect one 3610 at a time, and will facilitate configuring multiple
3610 via the same Virtual COM port (for administrators' or factory use).
Here is the setup barcode for this serial command:
254
User Guide
Config
DefaultSetting
SingleConnection
MultiConnection
UseOnePortforAll
Enter Setup