Usb Virtual Com Via 3610; Activate Usb Virtual Com; Activate Usb Virtual Com_Cdc; Inter-Function Delay - CipherLab 1662 User Manual

1662/1664 Barcode Scanner

2.5 USB VIRTUAL COM VIA 3610

Connect 3610 to the USB port of PC, and then connect the scanner to 3610. You may run
HyperTerminal.exe on the computer to view and capture the data transmission from the
scanner.

2.5.1 ACTIVATE USB VIRTUAL COM

Note: If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM. Driver version 5.4 or later is required. Please remove older versions
before installing new ones!

2.5.2 ACTIVATE USB VIRTUAL COM_CDC

Note: 3610 with firmware version 2.0 or later supports this function.

2.5.3 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of milliseconds, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
milliseconds).
3) Read the "Validate" barcode on the same page to complete this setting.
86
User Guide
Value" barcode on page 261 for the desired inter-function delay (in
Activate 3610
USB Virtual COM
Activate 3610
USB Virtual COM_CDC
Inter-Function
Delay... (*0~254)
Enter Setup