Example - CipherLab 1662 User Manual

For example, '#@GLED,09' is to have the scanner blink for 9 times.
"0x23" + "0x40" + "0x47" + "0x4c" + "0x45" + "0x44" + "0x2c" + "0x30"
+ "0x39" + "0x0d"
#@VIBR,nn<CR>
Purpose Have the scanner vibrate as many times as you specified ranging from 00 to 99
(00 is to stop the work). The length of vibrating time is based on the Good Read
Vibrator Duration setting and the constant interval between two shakes is
500ms.
Remarks nn – the two digits of command parameters
For example, '#@VIBR,09' is to have the scanner blink for 9 times.
"0x23" + "0x40" + "0x56" + "0x49" + "0x42" + "0x52" + "0x2c" + "0x30"
+ "0x39" + "0x0d"
#@RDBATCAP<CR>
Purpose Get battery capacity information.
Remarks "0x23" + "0x40" + "0x52" + "0x44" + "0x42" + "0x41" + "0x54" + "0x43"
+ "0x41" + "0x50" + "0x0d"

EXAMPLE

You may run HyperTerminal.exe on the host computer to send serial commands to the
scanner via USB Virtual COM or Bluetooth
For the scanner to stop immediately –
D
For the scanner to resume working –
E
For the scanner to change the beeper to medium volume and beep –
#@101011<CR>
#@////<CR>
For the scanner to change the beeper to minimal volume and beep –
#@101010<CR>
#@////<CR>
For the scanner to change the beeper frequency to 8 kHz (for Good Read Beep only)
and beep –
#@101001<CR>
#@////<CR>
For the scanner to change the beeper length to longest (for Good Read Beep only)
and beep –
#@101008<CR>
Appendix II
®
SPP.
Update
Host Serial Commands
251