Direct Usb Virtual Com; Activate Usb Virtual Com; Activate Usb Virtual Com_Cdc; Inter-Function Delay - CipherLab 1662 User Manual

2.7 DIRECT USB VIRTUAL COM

1662/1664 supports "Direct" USB Virtual COM interface for memory mode. Use the
provided USB cable to connect 1662/1664 to the USB port of PC. You may run
HyperTerminal.exe on a computer to view and capture the scanned data being
transmitted to the computer. Refer to

2.7.1 ACTIVATE USB VIRTUAL COM

Note: If using USB Virtual COM for the first time, install its driver from the CD-ROM.
Driver version 5.4 or later is required. Please remove older versions before
installing new ones!

2.7.2 ACTIVATE USB VIRTUAL COM_CDC

Note: If using USB Virtual COM_CDC for the first time, install its driver from the
CD-ROM.

2.7.3 INTER-FUNCTION DELAY

By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of milliseconds, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
1) Read the barcode above to specify the inter-function delay.
2) Read the "Decimal
milliseconds).
3) Read the "Validate" barcode on the same page to complete this setting.
1.2.2 Memory
Value" barcode on page 261 for the desired inter-function delay (in
Chapter 2
Mode.
*Activate Direct USB
Virtual COM
*Activate Direct USB
Virtual COM_CDC
Inter-Function
Delay... (*0~254)
Update
Selecting Output Interface
99