Aiming Mode (1664 Only); Multi-Barcode Mode - CipherLab 1662 User Manual

1.7.4 AIMING MODE (1664 ONLY)

The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.
The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
1) Read the barcode above to specify the time interval in seconds before aiming ends. (It is set
to 1 by default.)
2) Read the "Decimal
to automatically shut down after being idle for 10 seconds.
3) Read the "Validate" barcode on the same page to complete this setting.

1.7.5 MULTI-BARCODE MODE

The scanner will be scanning as long as the trigger is held down, capable of decoding one
single barcode, as well as multiple unique barcodes one at a time. While decoding a
bunch of unique barcodes, if a barcode is decoded twice, its subsequent decoding will be
ignored and the scanner is expecting another unique barcode.
The scanning won't stop until you release the trigger.
Note: (1) A barcode is considered unique when its Code Type or data is different from
others.
(2) Multi-Barcode Mode is not related to the
Value" barcode on page 261. For example, read "1" and "0" for the scanner
Chapter 1 Understanding the Barcode Scanner
Aiming Mode
Aiming Time-out
after 1~15 sec.
(*1)
Multi-Barcode Mode
Multi-Barcode
Update
Editor.
39