3610 Setup Barcodes & Serial Commands - CipherLab 1662 User Manual

3610 SETUP BARCODES & SERIAL COMMANDS
Normally, configure the 3610 dongle by having a connected scanner read 3610-related
setup barcodes.
1) Connect 3610 to the USB port of PC. You will need to install its driver first!
2) Refer to 3.1.1 Connect to 3610
Read the "Set Connection" label first, and then the "Serial Number" label. Both labels
can be located at the back of 3610.
3) Read the following barcodes in sequence to configure 3610.
For 3610-related setup barcodes, refer to the Setup Barcodes list below. Note that for the
"Version" and "GetID" barcodes, you must run HyperTerminal.exe or any text editor to
receive or view the information.
If the output interface is USB Virtual COM, run HyperTerminal.exe on the host
computer to receive the information.
If the output interface is USB HID, run any text editor to receive the information.
for the target scanner to connect to 3610.
Enter Setup
Appendix II Host Serial Commands
(3610-related setup barcodes)
Update
Update
253