Select A Set For Character Substituion - CipherLab 1662 User Manual

5.2.1 SELECT A SET FOR CHARACTER SUBSTITUION

1) Read the barcode above to enable character substitution by set.
For example, read the "Set 1" barcode to configure the first set of character
substitution. The scanner will respond with one short beep, high tone, to indicate
more setup barcodes are required.
2) Read the "Hexadecimal
substitution. For example,
KEY TYPE = NORMAL
Read "3", "0", "2", and "D" to replace the character "0" with a dash "-".
Read "3", "0", "2", "D", "3", and "0" to replace the character "0" with a dash "-0".
KEY TYPE = SCAN CODE
If you want to replace the character "0" with "a" (= "1C" on the scan code table):
1. Read "3" and "0".
2. Read the "Scan Code" barcode.
3. Read "1" and "C".
KEY TYPE = NORMAL + KEY STATUS = SHIFT
If you want to replace the character "0" with "!" (= "Shift" + "1" on keyboard):
1. Read "3" and "0".
2. Read the "Add Shift" barcode.
3. Read "3" and "1".
3) Read the "Validate" barcode to complete this setting. (The defined set or sets will be
applied to all symbologies by default.)
Configure Set 1
Configure Set 2
Configure Set 3
Value" barcode on page 262 for the desired character
Chapter 5 Defining Output Format
Update
175