Brake Lining Replacement - Sony SRW-5000 Maintenance Manual

5-12. Brake Lining Replacement

Outline
Replacement
1. Removing the Brake Assembly
2. Attaching the Brake Assembly
Adjustment after Replacement
3. Reel brake clearance check
Note
. When the brake lining is worn, replace the whole brake assembly.
. The parts making up the brake assembly is diffrent between S side and T side.
However, how to replace the brake assembly is the same for both sides.
Preparation
1. Turn the power off and disconnect the power cord.
2. Remove the upper lid (front) assembly. (Refer to Section 1-3-1.)
3. Remove the cassette compartment. (Refer to Section 1-5.)
Removal
1. Removing the Brake Assembly
(1) Unhook the spring put on the reel motor
assembly.
(2) Release the claw by pressing in the arrow
direction, then remove the brake assembly.
Installation
2. Attaching the Brake Assembly
(1) Pass a new brake assembly through the shaft
of the reel motor assembly and fix it with the
claw.
(2) Hook the spring to the reel motor assembly.
Adjustment after Replacement
3. Reel brake clearance check
n
Perform this check while the cassette compart-
ment is removed.
(1) Turn on the power.
(2) While the reel table is rotating, check that the
brake lining does not contact with the reel
table at the reel tables of S and T sides.
SRW-5000/5500
Brake assembly
Claw
This figure shows the T side.
Remove/Attach the Brake Lining
Shaft
Reel motor assembly
5-45