Sony SRW-5000 Maintenance Manual page 105

[F1] (DIAL) Key
Performs the operation checks for the search dial.
Execution Procedure
1. On the PANEL CHECK menu, press the [F1] (DIAL)
key.
. The status of the search dial is displayed.
DIAL PANEL MAINTENANCE MENU
F1
DIAL TEST
MFD
F2
Dial data
Dial direction
JOG/SHUTTLE sensor : SHUTTLE
F3
Dial mode sensor
KEY
BEEP
F4
LCD OEL KEY
DIAG
ALT F5 F6 F7
2. Turn the search dial to check the change of the status
display.
Dial data: The number changes as follows
by turning the search dial.
2Bh is displayed for the full
counterclockwise position.
2Ch is displayed for the full
clockwise position.
00h is displayed for the center
position.
Dial direction: The arrow changes as follows by
turning the search dial:
8 is displayed for the right
position from the center.
7 is displayed for the left
position from the center.
(The arrow does not change from
the previous direction at the center
position.)
JOG/SHUTTLE sensor:
JOG is displayed while the search
dial is pressed.
SHUTTLE is displayed when the
search dial is released.
n
When the Dial mode sensor is D-
2, not become the indication to the
JOG mode even it the search dial
is pressed.
SRW-5000/5500
: 00h
:
: D-2
LED EXIT
F8 F9 F10
Dial mode sensor: The setting status of the Dial
mode is displayed.
D-2:
BETACAM: Pressing the Search
To change the Dial mode, fix the
control panel at 90 d position and
loosen the screw located at the
backside of the search dial. Move
the mode selection plate to the
arrow direction until it would not
go any further. The mode display
switches to BETACAM/D-2.
Lower control panel
Search dial
< As seen from backside >
Mode selection plate
The mode does not
become the JOG
mode even it the
search dial is
pressed. (factory
setting)
dial switches
between the SHUT-
TLE/VAR mode
(displayed as
"SHUTTLE") and
the JOG mode
alternately.
B3 x 14
3-11