Sony SRW-5000 Maintenance Manual page 189

3. Cue up an alignment tape of the selected format to the tape beginning, and insert it.
When [F5] (REC ADJ) is selected, insert a recordable cassette tape.
n
. The adjustment cannot be performed correctly with a non-specified cassette tape. Be sure to use the
following alignment tapes:
Selected format
Alignment tape
. Pay attention to the transport start position of the tape so that the end and beginning of the tape are
not detected during adjustment. If the cassette is forcibly ejected during the automatic adjustment,
the adjustment is cancelled, its result is detected, and the display returns to the initial window. The
minimum tape amount required for the normal automatic adjustment is shown in the following
table: however, the tape amount increases or decreases when the adjustment is abnormal.
Menu
VCA ADJUST
EQULZR ADJUST
REC ADJUST
PLAY PLL ADJUST
FWD PLL ADJUST
REV PLL ADJUST
AD GAIN ADJUST
F1
F2
F3
F4
DIAG
ALT
SRW-5000/5500
HDCAM SR HDCAM
HR5-1B HR5-1A
Upper level: Normal adjustment time
Lower level: Tape amount required (Transport mode)
About 10 min./ALL, about 25 sec./channel
Adjustment time (PLAY)
About 12 min./ALL, about 30 sec./channel
Adjustment time (PLAY)
About 8 min./ALL, about 1 min./channel
Adjustment time (REC)
About 12 min./ALL, about 30 sec./channel
Adjustment time (PLAY)
About 30 sec./ALL, about 30 sec./channel
Adjustment time (FWD)
About 30 sec./ALL, about 30 sec./channel
Adjustment time (REV)
About 10 min./ALL, about 25 sec./channel
Adjustment time (PLAY)
NVRAM HDCAM-SR FORMAT RF ADJUST
CTL
VCA
FMT
[HDCAM-SR]
SEL
To adjust all channels,
press F6 key.
To select the channel,
press F7 key.
ALL CH CH
ADJ SEL
F5 F6 F7 F8
Digital BETACAM
(HKSR-5002 installed model only)
ZR5-1 (59.94 Hz mode)
ZR5-1P (50 Hz mode)
EXIT
F9 F10
3-95