Sony SRW-5000 Maintenance Manual page 167

[F5] (RF SW POS SR) Key
Performs the RF switching position adjustment.
m
. Perform this adjustment in 59.94 Hz mode. This adjustment does not need to be
adjusted in the other modes.
. Use the alignment tape HR2-1B for the adjustment. The adjustment cannot be
performed correctly with a non-specified cassette tape.
. Rewind the alignment tape to the tape beginning in advance.
Execution Procedure
1. In the ALT SERVO ADJUST menu, press the [F5] (RF SW POS SR) key to
display the RF SW POSITION menu.
2. Press the [SET] key.
3. Insert the alignment tape HR2-1B rewound to the tape beginning.
. Adjustment is executed automatically when the alignment tape is inserted.
The message "Auto Adjusting..." is displayed during the adjustment.
4. Confirm the result of the adjustment.
. When the adjustment is completed normally, the message "Auto Adjust
Complete" is displayed, and the alignment tape is ejected automatically.
n
If "Auto Adjust Failure" is displayed, refer to "For Automatic Adjustment
Failure" on page 3-75.
5. To save the adjusted data, press the [F1] (NVRAM CTL) key to display the
NV-RAM CONTROL menu, and execute "SAVE ALL DATA".
SRW-5000/5500
NVRAM ALT SERVO ADJUST
F1
CTL
RF SWITCHING POS.
CAPSTN
F2
GAIN
Press SET key.
T REEL
F3 GAIN
TENSN
OFFSET
F4
RF SW RF SW
DIAG
POS SR POS HD
ALT F5 F6 F7 F8 F9 F10
2. [SET]
ALT SERVO ADJUST
Set
HR2-1B
Alignment tape
3. Insert the
alignment tape
ALT SERVO ADJUST
RF SWITCHING POS.
Auto Adjusting. . .
PG :
ALT SERVO ADJUST
RF SWITCHING POS.
Auto Adjust Complete
PG : 2514
SRW-5500
EXIT
3-73