Sony SRW-5000 Maintenance Manual page 271

17. Reattaching the Gear Box Assembly
Reattach the gear box assembly.
(Refer to steps 5 and 6 in Section 5-17.)
18. Reattaching the Pinch Press Assembly
Reattach the pinch press assembly.
(Refer to steps 3 and 4 in Section 5-9.)
19. Putting the Unit into the Unthreading
End Mode
(Refer to step 2 in Section 5-1-2.)
20. Reattaching the S Tension Regulator
Assembly
Reattach the S tension regulator assembly.
(Refer to step 2 in Section 5-19.)
21. Reattaching the S Plate Assembly
Reattach the S plate assembly.
(Refer to step 2 in Section 5-16-1.)
22. Reattaching the T Drawer Assembly
Reattach the T drawer assembly and confirm the
T drawer assembly operation.
(Refer to steps 3 to 6 in Section 5-21.)
23. Attaching the CL Guide Rail
(1) Check if the deck is in the unthreading end
state.
(2) Insert the portion A of the CL guide rail to
the bottom of the drum.
(3) Match and attach the positioning pin of the
CL guide rail to the positioning hole of the
MD base assembly.
(4) Tighten the two screws.
24. Confirming the CL Arm Assembly
Operation
Confirm the CL arm assembly operation.
(Refer to step 3 in Section 5-5.)
25. Reattaching the PA Guard
(1) Put the PA guard through the cassette brace,
then match the pins with the holes of the MD
base assembly.
(2) Tighten the one screw.
Tightening torque: 78.4 x 10
{8.0 kgf.cm}
SRW-5000/5500
Positioning pin
_2
N.m
CL guide rail
B3 x 12
Attach the CL Guide Rail
PWH3 x 8
Attach the PA Guard
B3 x 12
Portion A
PA guard
5-65