Sony SRW-5000 Maintenance Manual page 264

Installation
2. Attaching the S Plate Assembly
(1) Insert the pins of the S plate assembly into
the holes of the chassis and tighten the screw
while drawing the assembly clockwise.
Tightening torque: 78.4 x 10
{8.0 kgf.cm}
c
As the edge of tape cleaner is sharp, use great
care to avoid a hand cut.
(2) Connect the harness (tape end sensor) to the
connector of the tape end sensor and fix it to
the clamper.
(3) Fix the remaining harnesses disconnected in
(2) of step 1 to the clamper
Adjustment after Replacement
3. Adjusting the Tape Running at Drum
Entrance Side
Refer to Section 6-12-1.
5-58
_2
N.m
Clamper
Fix the Harnesses
SRW-5000/5500