Removing/Reattaching Ac Panel - Sony SRW-5000 Maintenance Manual

1-3-4. Removing/Reattaching AC Panel

w
For your safety against electric hazards, be sure to turn off
the power and unplug the power cord before removing/
reattaching.
1. Remove the connector panel assembly.
(Refer to Section 1-4.)
2. Remove the side panel (left). (Refer to Section 1-3-3.)
3. Remove the four screws and two washers securing the
AC panel assembly.
BVTT3 x 6
AC panel assembly
4. Slide the cable protector in the arrow direction to remove.
5. Remove the bead tie and open the edge holder.
n
This step is not required when both option HKSR-
5001 and HKSR-5003 are installed.
6. Dicconnect the all coaxial cables connected to the
plug-in boards.
n
Hold the plug to remove the coaxial cables in discon-
necting the coaxial cables from the connector on the
boards. (Refer to Section 1-12.)
1-4
7. Remove the coaxial cables from the guide rail (L).
Bead tie
8. Remove the AC panel assembly in the arrow direction.
9. Discconnect the harnesses from the AC inlet.
10. Pull out the all coaxial cables from the chassis hole
and correctly remove the AC panel assembly.
n
Do not pull the coaxial cables forcedly.
BVTT3 x 6
AC panel assembly
When reattaching, install in the reverse order of removal.
m
. Connect the harnesses to the AC inlet correctly.
. For connecting connector of the coaxial cables, refer to
Section 1-12.
Cable protector
Edge holder
Coaxial cables
Harnesses
AC inlet
Guide rail (L)
Chassis hole
Coaxial cables
brown
green/yellow
white
SRW-5000/5500