Sony SRW-5000 Maintenance Manual page 367

5. Adjust the AT Head Position
(1) Loosen the two securing screws of the AT
head assembly by 1/4 to 1/2 turn.
(2) Turn on the power, then play back the HR2-
1B (00:00 to 20:00) in the PLAY mode.
(3) Insert a 3 mm flatbladed screwdriver into the
notch of the AT head assembly.
(4) Adjust the AT head assembly position so that
the specification is satisfied.
m
. The specifications in AT head position
check and position adjustment differ. When
adjusting, apply the specification in AT
head position adjustment.
. The TC signal is in 0.15 ms advance of the
CTL signal.
(5) Tighten the two screws loosened in step (1).
Tightening torque: 98 x 10
{10.0 kgf.cm}
6. Recheck the AT Head Position
Perform previous step 3 in this section again.
7. Attach the CL Guide Rail
(1) Turn off the power, then remove the align-
ment tape.
(2) Attach the CL guide rail with two screws.
After the Adjustment
8. Check the AT Head Height
Refer to Section 6-7.
9. Check the AT Head Azimuth
Refer to Section 6-8.
10. Check the AT Head Head-to-tape
Contact
Refer to Section 6-9.
11. Check the AT Head Position
Refer to step 3 in this section.
12. Apply the Locking Compound
Refer to Section 6-1-9.
SRW-5000/5500
. Alignment tape : HR2-1B (00:00 to 20:00)
_2
N.m
CTL PULSE
Spec. : A = 0.15 ±0.40 ms
Securing screw
(PSW3 x 8)
Notch
65 35
A
TC PB
AT Head Position Adjustment
Securing screw
(PSW3 x 8)
AT head
50 50 35 65
6-37