Cp-377 Board - Sony SRW-5000 Maintenance Manual

5-30-4. CP-377 Board

Replacement
1. Turn the power off and disconnect the power
cord.
2. Remove the connector panel assembly.
(Refer to Section 1-4.)
3. Remove the CP-376/CP-376A board.
(Refer to Section 5-30-3.)
4. Remove the screw (PSW3 x 8) fixing the lug
terminal to the CP-378 board.
5. Remove the two screws (BVTT3 x 6).
6. Remove the eight screws (BVTP3 x 10)
fixing the BNC connectors and remove the
CP-377 board.
n
Be careful not to loose the SW ornamental
plates and the ornamental plate spacers at this
time.
7. Perform the removal in the reverse order
from steps 2 to 5.
n
Fix the rug terminal of the ground harness to
the CP-378 board properly.
Steps after Replacement
8. Check if the component video output signal
and composite video output signal are
normally output. (Refer to Section 1-25-6.)
SRW-5000/5500
Ornamental plate spacer
Switch ornamental plate
BVTT3 x 6
BVTP3 x 10
Connector panel
assembly
Remove the CP-377 Board
CP-377 board
Lug terminal
CP-378 board
PSW3 x 8
5-107