Sony SRW-5000 Maintenance Manual page 289

Installation
6. Soldering the Harness
Solder the harness's wires disconnected in (2) of
step 5 to a new motor.
n
Solder a red wire to the side of marking "+" of
the motor.
7. Attaching the Motor Joint
(1) Pass the motor joint through the shaft of the
motor and temporarily tighten the set screw.
(2) Confirm that the clearance between the motor
joint and motor satisfies the specification
when the motor joint is pushed toward the
motor, and tighten the set screw.
Tightening torque: 60 x 10
{6 kgf.cm}
SRW-5000/5500
_2
N.m
Cassette compartment motor
+marking
Red
Harness Soldering
Set screw
Cassette compartment motor
Motor joint
Motor joint
Cassette compartment motor
Spec.: 3.8 mm
Attach the Motor Joint
Gray
Press
A
A
4.2 mm
5-83