8-1. Electrical Alignment Overview
8-1-1. Precautions
. Be sure to adjust each block in order unless any instructions are provided.
. Do not contact with adjusting part when other than required.
. Do not execute automatic adjustment, and do not change adjustment data when other than required.
In case either of these is done unintentionally, do not save the data. To recover it, turn off the power of
the VTR .
. For details on the maintenance mode, refer to Section 3.
. Before beginning adjustment, it is recommended to make a copy of setup conditions. If customer
conditions are noted, the settings can be returned easily to its customer condition after finishing adjust-
ment.
Settings of switches on panels, circuit boards:
Use the setting check sheets. (Refer to the installation manual.)
Settings of the setup menu:
Use a Memory Stick or memory card. (Refer to "1-26. Memory Stick (or Memory Card)".)
8-1-2. Outline of Electrical Alignment
In Section 8 explains the all electrical adjustment to each block.
Block
Reference
Power supply unit
Section 8-2
Servo/DT
Section 8-3
RF
Section 8-4
Audio
Section 8-5
CUE
Section 8-5
SD Video
Section 8-6
HD Video
Section 8-7
Full erase, Time code
Section 8-8
Tele-File
Section 8-9
SRW-5000/5500
Section 8
Electrical Alignment
Contents
Output voltage check of power supply unit
Servo system and DT system alignment
RF system alignment
Adjustment of Analog audio output line
Adjustment of CUE line
SD SDI free-running frequency adjustment
Adjustments of Analog composite Video output
HD Video system adjustment
LTC system adjustment/check and Full erasure current check
Tele-File system adjustment
Object of adjustment
———
DT-47, DR-508, SS-95
EQ-94
APR-62
AE-31H, CUE-13
VPR-79
HPR-8/HPR-8A
TC-104
DIO-69
8-1