Sony SRW-5000 Maintenance Manual page 23

Installation
6. Place the cassette compartment into the unit in the
direction as shown in the figure (with the cassette lid
down).
m
. Being careful not to contact the gear on the right of
the cassette compartment with the chassis, slowly
insert the cassette compartment into the unit while
slightly sliding it back-and-forth.
. Never move the cassette compartment to the right
and left. If unnecessary force is applied to the right
and left, the gear or part may come off.
SRW-5000/5500
7. Press the portions C of the cassette compartment as
shown in the figure, and then fit the four positioning legs
into the four positioning holes in the mechanical deck.
Be sure to attach the cassette compartment while
pressing down the portion D of the SC Guide Assem-
bly by fingers.
If not, the cassette compartment cannot be attached
properly because the back of the stage end of the
cassette compartment blocks portion D.
Cassette compartment
Cassette lid
Positioning leg
Flexible card
wire/board
Positioning hole
SC guide assembly
8. Connect the harness to the connector (CN930) on the
CL-29 board.
9. Being careful not to pinch the harness, reattach the
cassette compartment bracket assembly.
10. Reattach the upper lid (front) assembly.
C
Gears
CN930
C
Harness
D
1-7