Sony SRW-5000 Maintenance Manual page 316

12. Connect the two flexible card wires discon-
nected in step 6.
13. Connect the CN-2511 board to the connector
CN301 on the CP-382 board as shown in the
figure.
14. Reinstall the CP-382 board to the key panel
frame, then fix it with the five screws.
Tightening torque: 80 x 10
{8.0 kgf.cm}
m
. Be sure not to be caught the harnesses
shown in the figure between the key panel
frame and CP-382 board.
. Connect the connector CN503 on the CP-
382 board to the CN1 on the KY-527 board
surely.
15. Connect the harness disconnected in step 4 to
the connector CN601 on the CP-382 board.
16. Reattach the rear cover.
(Refer to step 4 in Secion 5-25.)
17. Reattach thecontrol panel assembly to the
unit. (Refer to Section 1-6.)
Steps after Replacement
18. After replacing the CP-382 board, perform
the "After replacing the NV-RAM" in
Section 1-25-8.
5-110
CN-2511 board
_2
N.m
CP-382 board
PSW3 x 6
CN301
CN-2511 board
CN1
KY-527 board
Attach the CP-382 Board
Harnesses
PSW3 x 6
CN503
CN700
CN502
CN601
CP-382 board
PSW3 x 6
SRW-5000/5500