Fp-131/132 Board - Sony SRW-5000 Maintenance Manual

5-30-11. FP-131/132 Board

Replacement
1. Turn the power off and disconnect the power
cord.
2. Remove the upper lid (front) assembly.
(Refer to Section 1-3-1.)
3. Remove the power supply unit.
(Refer to Section 5-24.)
4. Disconnect the DIO-69 board.
(Refer to Section 5-30-8.)
5. Open the lower control panel.
(Refer to Section 1-6.)
6. Disconnect the connecting cable of the
control panel.
7. Remove the two screws fixing the FP fixed
plate assembly.
8. Disconnect the connector on the MB-964
board to pull out the FP fixed plate assembly
from the chassis.
9. Remove the two screws (A) to remove the
FP-132 board.
10. Remove the four screws (B) to remove the FP
bracket and the FP fixed plate.
11. Perform the installation in the reverse order
from steps 2 to 10.
Steps after Replacement
12. After replacing the FP-131 or FP-132 board,
check the operation of the board.
(Refer to Section 1-25-14 or 1-25-15.)
SRW-5000/5500
MB-964 board
FP fixed plate assembly
BVTT3 x 6
Connecting cable
Remove the FP Fixed Plate Assembly
BVTT
3 x 6
FP fixed plate
Remove the FP-131/132 Board
Guides
BVTT3 x 6
FP-132 board
FP bracket
FP-131 board
BVTT3 x 6
5-117