Capstan Motor; Capstan Brake Assembly V++Rrevrsrrrrrterttrtees - Sony SLV-E105 Service Manual

3-7. CAPSTAN MOTOR
3-7-1. CAPSTAN MOTOR (See Fig.3-7-1)
1)
Refer to section 3-2, then remove the mechanism unit.
2) Remove the two screws @), then remove the harness
mounting @.
3) Remove the reel belt @.
4) Remove the three screws©® and the capstan motor©.
ASSEMBLY NOTES:
1. Check that connector @ is inserted in the CP-1 PWB
assembly.
2. When fitting the three screws@, use the torque
gauge screwdriver (VHJ-0014). Give the screws a
tightening torque of 3.5 kg/cm.
3. After assembly, clean the capstan shaft with a soft
cloth or chamois.
®Screws
@Reel belt ®
Fig. 3-7-1
5-14
3-7-2. CAPSTAN BRAKE ASSEMBLY (See Fig.3-7-2)
1) Remove the spring @.
2) Remove the clamp @, then remove the capstan brake
assembly @.
@Spring
@Capstan brake
assembly
Fig.3-7-2