Table of Contents
Advertisement
SECTION 2
SLV-E105/E1101T
DISASSEMBLY
1-1. REMOVAL OF CABINET, MECHANISM UNIT, AND MAIN BOARD
REMOVING THE CABINET PARTS (Fig. 1-1-1)
1.
Remove the cabinet and bottom cover by removing the
four screws @ and four screws @.
2.
Remove
the front panel by removing the locks of the
clamps (A) using a screwdriver, etc., and slightly rotating
the bottom part in the direction of the arrow.
Notes:
~° Electrical adjustments for the this model can be
performed with only the cabinet removed.
« When replacing the bottom cover, do not tighten
the screws @ too much.
Excess tightness
may
damage the screw taps on the chassis.
REMOVING THE MECHANISM MAIN UNIT AND THE
CP-1 PWB ASSEMBLY (Fig.1-1-2 and 1-1-3)
After removing the cabinet parts, remove the mechanism
unit and the CP-1 PWB assembly connected as follows.
1.
First, remove the red screw @) of the TB-1 PWB, spread
out lock clamps (B) and (C) in the arrow direction slightly
and
remove
TM-1
PWB
and TM-2
PWB
as shown
in
Fig. 1-1-2.
Clamps(A)
2.
3.
Remove the screw @ at the back of the chassis.
Remove the red screw © in the chassis, remove the red
screw ©), and remove the holder in this order.
Remove the two screws@ and two screws @®) of the
mechanism unit. The two screws ©) of the cassette tray
can be removed easily by pushing the tray lock lever in
the arrow direction to remove the lock as shown in the
enlarge view A and by pushing the lid opener lever in
the arrow direction to remove the lock as shown in the
enlarge view B.
Lift up the whole mechanism unit and main board (CP-1
PWB assembly), and as shown in Fig. 1-1-3, push the two
lock clamps (D) of the chassis in the arrow direction so
that they can be removed from the chassis.
Main Unit
Bottom Cover °
Fig. 1-1-1
Advertisement
Table of Contents
