Installing Tips - µ-Dimension 180-00108 uPrint User Manual

Troubleshooting and Maintenance
B. Use needle nose pliers to grasp the stainless steel shield of the tip.
C. Pull the tip shield toward you, then pull down to remove the tip from the heater block. Discard the
used tip. See
Pull tips down to
remove
D. Repeat for second tip if necessary.

Installing tips:

1. Place the tip shield on the tip. Be sure to install the proper tip. See
Document Number 206465-0001
Figure 52.
Figure 52: Remove the tips
Figure 53: Identifying Tips
Support Tip
Left Side
Heater block
Figure 54
Model Tip
Right Side
64
User Guide