Table of Contents
Advertisement
Setup
C. Enter the dynamic IP address for your printer (from step 2B) in the appropriate field.
D. Select the appropriate printer type from the drop down list.
E. Click Add Printer and close the 3D Printer pop-up window.
F. If you get an "Error: Unable to connect to printer" message it may be that your PC is not
configured for dynamic networking. To configure your PC for dynamic networking:
From the Control Panel of your PC, double click on Network and Internet Connections.
i.
Double click on Network Connections, then double click on Local Area Connection.
ii.
iii. Scroll the Local Area Network Connection Properties window to find the Internet Protocol
(TCP/IP) selection. Click on Internet Protocol (TCP/IP) and then click on the Properties
button.
iv. From the General tab of the Internet Protocol (TCP/IP) properties pop-up window, click on
the Obtain IP Address Automatically radio button.
Click OK and then OK again.
v.
vi. After allowing your PC a minute or so to adjust to the new setting, your PC should connect to
your printer.
vii. If you are still unable to connect to your printer, recheck your connections and settings.
System Software
The system software is factory loaded on the printer. Due to occasional changes you may need to update
the printer system software.
Updating system software:
1. From the uPrint display panel, press Maintenance.
2. Press System.
3. Press Load Upgrade. The printer will then display "Send upgrade from workstation" followed by
the printer's IP address.
4. Open CatalystEX and click on the Printer Services tab.
5. Click on the Update Software button. CatalystEX will now connect to the printer and will prompt you to
locate the upgrade file. Navigate CatalystEX to the CD where the upgrade file is located. The update
will automatically be loaded on to the printer. After the update has been loaded, the display will show
Verifying update.
6. When verification is complete, the display will show Reboot to complete. Select Yes. The printer will
now reboot and return to Idle.
7. Press the maintenance button and verify the updated version was installed correctly.
Document Number 206465-0001
26
User Guide
Advertisement
Table of Contents
