Setting The Static Network Address - µ-Dimension 180-00108 uPrint User Manual

Setup

Setting the static network address:

1. Obtain your static network address from your Network Administrator.
2. From Idle (or Ready to Build), press Maintenance on the display panel. The display will show Main-
tenance and the software version.
3. Press System.
4. Press Set Network. The top window displays: Network Admin - Static IP Address; UDN.
5. Press Static IP to display current settings. For example:
IP Address:
NM Address: 255.255.000.000
GW Address: 198.000.000.001
6. Look for the cursor beneath the first digit of the IP Address. The cursor does not blink. To update the IP
address:
Press Increment to increase the value one digit at a time.
Press Next Digit to move the cursor one place to the right.
Press Last Digit to move the cursor one place to the left.
7. Use the three functions listed above to set your IP address.
8. After setting the final digit of the Internet Protocol (IP) address, move the cursor one more place to the
right. The cursor moves to the Netmask (NM) address. Follow the same steps for setting the NM and
Gateway (GW) addresses.
9. When you have finished setting the addresses, from the display panel press Done. The display will
show: Change IP, Netmask and Gateway?
10. Press Yes. The panel then displays Resetting Network and after a moment returns to Idle or starts
warming up.
11. From your PC, start the CatalystEX application.
A. From the General Tab, click the Manage 3D Printers button.
B. Click the Add from Network button in the lower right corner of the pop-up window.
C. A new pop-up window, Add 3D Printer, should list your printer in the main window (identified by its
UDN). Click on the printer in this window and enter a name and location in the lower portion of the
pop-up window.
D. Click Add Printer and you are ready to go. Close the 3D Printer pop-up window.
Document Number 206465-0001
192.000.000.001
These values are the factory defaults and MUST be changed
for your network. If these values are not changed the printer
will continue to restart itself until they are changed.
Note:
24
User Guide