Clogged Extrusion Tip - µ-Dimension 180-00108 uPrint User Manual

Troubleshooting and Maintenance

Clogged extrusion tip

Occasionally, an extrusion tip may clog with material. This is often accompanied by a loss of extrusion
(LOE). A clogged tip will prohibit material load and part building.
To clear a clogged extrusion tip:
1. From the display panel press Maintenance.
2. Press Machine.
3. Press Head.
4. Remove the head cover by pressing the tabs in and pulling away from the head. See
5. Remove the air plenum by pressing the tabs in and pulling away from the head. See
Document Number 206465-0001
It is recommended that you read and understand this entire
procedure before performing any of the work.
This procedure assumes that material is loaded to the
extrusion tip. If material has not been loaded, see
material carriers to single material bay" on page 29
"Adding material carriers to the dual material bays" on
page 30
Figure 41: Remove the head cover
Note:
"Adding
or
Figure 41
Press tab in to remove head
cover
Figure 42
User Guide
54