Material Bay Leds - µ-Dimension 180-00108 uPrint User Manual

Operation
6. Open the carrier.
7. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the filament guide. See
Figure 35
8. Using a cutters, cut the excess 2 inches (50mm) of material from the filament guide, leaving a blunt
end.
9. Replace the material spool.
10. Close and latch the carrier.
11. Once the material carriers have been replaced press Load...
12. You can select which carriers you want to load to the head by selecting Next Model or Next Support.
When done selecting press Load Selected.
13. The printer will now load the selected material bays and prepare the other bays for automatic loading.
After they are done loading and preparing, press Done... the display will show Wait for Part or Ready
to Build.

Material bay LEDs

The table below will show the status indicated by the LEDs.
●
On
○
Off
☼
Blinking
Document Number 206465-0001
Do not push the material through the filament guide back into the carrier,
doing so can cause material to break or become tangled.
Figure 35: Rewinding the material spool
Material currently loaded to the head
No carrier present
Carrier present and ready to be loaded
Carrier needs replacement (is empty or has an error)
CAUTION
Rewind the material back onto
the material spool
45
User Guide