Pausing A Build; Resuming After Pause; Canceling A Build; Removing A Completed Part - µ-Dimension 180-00108 uPrint User Manual

Operation

Pausing a build

While building a part, you may want to pause the build to allow for material replacement. To pause the
build at any time, from the display panel press Pause.

Resuming after pause

If you have pressed Pause, and are ready to resume building the part, press Resume and the printer will
resume printing.

Canceling a build

You can cancel a build at any time while the part is building.
1. From the display panel press Pause.
2. Once the printer stops building, press Cancel Build.
3. The display will ask Are you Sure? Press Yes.
4. The display will show Build Stopped followed by the file name. You will then be prompted to remove
the part and replace the modeling base.
5. Remove the part and replace the modeling base. Once the chamber door has been opened and
closed, the display will ask Part Removed? Press Yes ONLY after you have removed the part and
replaced the modeling base.

Removing a completed part

When the printer has completed building a part, the display will show Completed followed by the file
name. It will also show Remove Part and Replace Modeling Base.
The modeling base will be hot, wear gloves when removing the part from the
1. Open the chamber door.
2. Turn the modeling base retainers down and remove the modeling base by sliding out and pulling up.
3. Insert a new modeling base by sliding in and pushing down, turn the retainers up to lock the modeling
base in place.
Document Number 206465-0001
The printer will complete the current tool path before
pausing.
If you press Yes before removing the part, the printer can be damaged.
Note:
CAUTION
CAUTION
printer.
41
User Guide