Troubleshooting and Maintenance
Tip shield replacement
Tip shields can become worn or damaged over time. This can have a negative impact on the surface finish
and detail of models. Replace the tip shields every 500 hours.
1. Enter Head Maintenance.
A. From the display panel press Maintenance.
B. Press Machine.
C. Press Head. The head will come to rest in the center of the chamber and the Z platform will
change position.
2. Remove the head cover by pressing the tabs in and pulling away from the head. See
3. Position the blade of the small screwdriver between the tip shield and tip plate. Use the blade of the
small screwdriver to separate the tip shield from the tip plate. See
Document Number 206465-0001
Figure 48: Tip Shield Damage
The head area is hot. Use gloves when working in this area of printer.
WARNING
Figure 49
61
Figure 41
User Guide