µ-Dimension 180-00108 uPrint User Manual page 56

Troubleshooting and Maintenance
7. Move the toggle bar to 'deactivate' the clogged tip.
8. Snip the material just after it passes between the drive wheel and the idler wheel ('pinch point').
9. Move the toggle bar to activate the clogged side. This will make the drive wheel control options active
for the clogged side.
10. Press Forward on the interface panel. The drive wheel will turn, but material will not feed because the
idler wheel is held out of position.
Document Number 206465-0001
Figure 44: Create access space for cleaning - model side shown
Push the toggle bar to the right to deactivate the support
side. Push the toggle bar to the left to deactivate the model
side.
If necessary manually pull more material forward in order to
reach the 'pinch point'.
Push the toggle bar to the left to activate the support side;
push the toggle bar to the right to activate the model side.
Note:
Note:
Note:
56
User Guide