Auto Power Down; Cancelling Auto Power Down - µ-Dimension 180-00108 uPrint User Manual

Operation
11. Remove the material spool from the material carrier. See
12. Place the material spool in the storage bag that came with the material carrier.

Auto power down

You can set the printer to automatically power down when it completes a build. This option will save energy
usage.
1. While the printer is building, press the Auto Power Down button.
2. Turn the power switch to the off position.
The printer will display Auto Power Down Mode and the printer will power down as soon as the build is
complete.

Cancelling auto power down:

1. Turn the power switch back to the ON position.
Document Number 206465-0001
Figure 39: Installing material retaining clips
Place clip here and push
down to lock in place
Figure 40: Properly installed material retaining clips.
When not loaded in the printer, always store material spools
in the material carrier or the storage bag that came with the
carrier to prevent moisture absorption.
Figure 40.
Note:
48
User Guide