Connecting The Printer And Material Bay(S) - µ-Dimension 180-00108 uPrint User Manual

Setup

Connecting the printer and material bay(s).

1. Connect the material tubes from the material bay(s) to the printer. The material tube with the red stripe
is for the model material and the material tube with the black stripe is for support material. See
13.
2. Connect the material bay communication cable(s) from the material bay(s) to the printer. DO NOT con-
nect the material bay communication cable(s) while the printer is powered on. See
Document Number 206465-0001
If you are using the optional second material bay, the longer
material tubes are for the lower material bay and the shorter
material tubes are for the upper material bay.
Figure 13: Material tube connections
Figure 14: Material bay communication cable
Note:
Firmly push tubes
into fittings
19
Figure
Remove only if
using the optional
material bay
Figure 14.
User Guide