Adding Material Carriers To Single Material Bay - µ-Dimension 180-00108 uPrint User Manual

Setup

Adding material carriers to single material bay

Once material spools have been inserted into the carriers, you will need to add the carrier to the material
bay. If using dual material bays see
An instructional video can be viewed at
1. From the display panel press Material, the display will show Add/Remove.
Press Material...
2. Add the model and support carriers to the material bay by inserting the carriers into the material bays
and pushing the carrier in until it latches. See
Insert support
material carrier
Document Number 206465-0001
"Adding material carriers to the dual material bays" on page 30
http://www.uPrintDimension.com/productinformation/customerinfo
Figure 22: Adding carriers to the single material bay
Figure 23
Figure 23: Insert carriers until they latch into place
29
Insert model material
carrier
User Guide