Setup
Installing material spools into material carriers
An instructional video can be viewed at
1. Place on a flat surface, unlatch and open carrier. See
Push in
2. Tear open the bag and discard. Note how the material and material guide are held in place with clear
plastic. See
Figure
3. Completely remove the clear plastic. DO NOT remove the material guide from the spool at this time.
4. Place the spool in to the carrier with the material guide facing up.
5. Remove the material guide from the spool holding location.
6. Carefully remove material from the spool detent. See
7. Place the model material guide into position see
Document Number 206465-0001
http://www.uPrintDimension.com/productinformation/customerinfo
Save the enclosed bag for storage. The storage bag is used
to store material spools when they are not in use and will
help keep moisture out of the material.
Figure 18: Opening the carrier
19.
Figure 19: Removing the material spool
Figure
18.
Note:
Material detent
Material spool
Retaining band
Material guide
Figure
20.
Figure 20.
27
User Guide