Tip Wipe Assembly - µ-Dimension 180-00108 uPrint User Manual

Troubleshooting and Maintenance

Tip wipe assembly

The tip wipe assembly should be replaced approximately every 500 hours.
1. Completely power down the printer. See
2. Move the head to the right of the printer to gain access to the tip wipe assembly.
3. Remove the tip wipe assembly by lifting the assembly up and out of the printer. Discard this tip wipe
assembly.
4. Place the new tip wipe assembly over the two mounting posts making sure the assembly is fully
installed.
Document Number 206465-0001
"Powering off" on page
Figure 46: Move the toggle head to the right
Figure 47: Replacing the tip wipe assembly
49.
60
User Guide