Building A Test Part - µ-Dimension 180-00108 uPrint User Manual

Setup 33

Building a test part

Factory test parts have been pre-loaded onto the operating system of your printer. To familiarize yourself
with the building process, it is recommended that you build one of these test parts before attempting to
build one of your own files.
Once the printer has reached Idle, material has been loaded and a modeling base has been installed, you
can build a test part with the printer.
1. From the display panel press Maintenance.
2. Press System.
3. Press Test Parts and select the sample wrench.
The printer will automatically start to print the test part. It will take approximately 45 minutes to complete
the build.
When the part is finished, follow the steps under "Removing a completed part" on page 41.
User Guide
Document Number 206465-0001