µ-Dimension 180-00108 uPrint User Manual page 28

Setup
Model
Support
8. Close the carrier with the material guide in place. Latch both buckles completely (the red tab must
snap in to place on each buckle). See
Document Number 206465-0001
Figure 20: Place model material spool into model material carrier
Model (red) and support (black) carriers are different. The
material guide tubes install on the opposite side. See
20.
Figure
Material must protrude 6.35mm (0.25 inch) from the end of
the material guide.
Figure 21: Latching the carrier
Note:
21.
Note:
Figure
User Guide
28