µ-Dimension 180-00108 uPrint User Manual page 17

Setup
5. Open the printer door and remove the substrate and Vapor Corrosion Inhibitor (VCI) emitter and dis-
card. See Figure 11.
6. Remove the shipping foam from the Z stage guide rods and recycle. See
7. Cut the tie wraps holding the belt retaining clips in place, remove the belt retaining clips and recycle.
See Figure 11.
Remove shipping foam
from Z stage guide rods
and recycle.
Document Number 206465-0001
Figure 11: Open the chamber door and remove shipping materials
The lead screw and guide rods are lubricated with a thin coat of Krytox
grease. Krytox grease can cause skin irritation. Be careful not to get the
grease on your hands or clothing.
Figure 11.
WARNING
Remove belt retaining clips
and recycle.
Remove modeling base with
VCI emitter and discard
User Guide
17