µ-Dimension 180-00108 uPrint User Manual page 47

Operation
6. Locate the two material retaining clips on the carrier. See
Material retaining clips
7. Place the material guide in the material guide slot on the spool. See
8. Place the material in the material detents. See
Material guide slot
9. Cut the excess material from material guide.
10. Place the material retaining clips on the spool before removing the spool from the carrier. See
39.
A. Push the material retaining clips over the material and clip on to the material spool.
B. Push the material retaining clips down until they lock in place.
Document Number 206465-0001
Figure 37: Material retaining clips
Figure
Figure 38: Material guide slot and detents
Figure 37.
Figure 38.
38.
Material detents
Figure
User Guide
47