µ-Dimension 180-00108 uPrint User Manual page 44

Operation
6. Open the carrier.
7. Rotate the spool to rewind the material, leaving 2 inches (50mm) remaining at the filament guide. See
Figure 34
8. Using a cutters, cut the excess 2 inches (50mm) of material from the filament guide. leaving a blunt
end.
9. Replace the material spool.
10. Close and latch the carrier.
11. Once the material carriers have been replaced press Load...
12. Select Load Model, Load Support or Load both.
13. After material has been loaded to the head press Done...
Replacing material for dual material bays
1. From the display panel press Material... The display will show Add/Remove and S1%,
S2(remaining%) and M1, M2 (remaining%). Asterisks will mark the currently active material bays (the
material bays that are currently loaded to the head).
2. Press Unload...
3. Press Unload both, Unload Model or Unload Support.
4. The printer will now unload material from the head. When the material has unloaded, you will need to
replace the material carriers.
5. Place the carrier on a flat stable surface.
Document Number 206465-0001
Do not push the material through the filament guide back into the carrier,
doing so can cause material to break or become tangled.
Figure 34: Rewinding the material spool
CAUTION
Rewind the material back onto
the material spool
44
User Guide