Installing Forklift Access Covers; Power Connections - µ-Dimension SST 1200es User Manual

18 Setup

Installing Forklift Access Covers

The forklift access covers can be placed over the forklift channels
after the printer is placed in its final location (see
covers are press-fit in the front and held in place with one screw in
the rear.
Insert Tab in Slot
Push Cover Toward Front
of Printer
Figure 4: Installing the forklift access covers

Power Connections

This section discusses the procedure for preparing all power
connections for the printer.
Dimension is provided with two power cords: one for 110 V and one
for 220 V.
Prepare all power connections:
1. Connect the male end of the supplied power cord directly into a
grounded electrical outlet, as shown in
using a Uninterrupted Power Supply (UPS), connect the cord
directly into the UPS).
Dimension BST 1200es / SST 1200es User Guide
Before connecting power to the printer,
make sure that the Dimension circuit
breaker is in the off (down) position. It is
located in the rear of the printer next to
the power cord attachment point.
Figure
Attachment Screw
on Back of Printer
CAUTION
Figure 5 on page
4). The
19. (If