Set Up The Material Bay And Printer - µ-Dimension 180-00108 uPrint User Manual

Setup

Set up the material bay and printer

Once the printer and the material bay are unpacked, they will need to be aligned and stacked before
operation.
1. Place the material bay on a stable, flat surface where you will have your uPrint 3D printer located.
2. Remove the shipping foam from the material bay doors. See
3. The material bay has 4 holes for the feet and 2 holes for the alignment pins. See
must be aligned properly for mechanical stability.
4. Align the 4 feet and 2 two pins on the bottom of the printer with the holes on top of the material bay and
set in place. See
Document Number 206465-0001
Figure 9: Remove the shipping foam from the material bay doors
Figure 10.
Use proper moving and lifting techniques when positioning the unit.
Figure 10: System stacked (shown with optional material bay)
Figure 9
LIFTING HAZARD
16
Figure 10. These
User Guide